DCC Booster board without the power supply. These boards can be used to make locomotive Power Districts or an Accessory District with a shared power supply. A jumper is used to set either Accessory Mode or Power District Mode. Each board can supply up to 3 Amps continuous duty and 5 Amp peak with a suitable power supply. These boards work very nicely with the Hex Frog Juicer.
Max power supply voltage: 40V
Power Connector: 5.5 mm (outer)/ 2.1 mm (inner) barrel plug, center positive
DCC input: optically isolated, 5-24 Volts (voltage level on the DCC input pins has no effect on output voltage level), 25 mA load typical.
DCC Connectors: Screw blocks
Max output: 5 Amps for short periods, 3 Amps continuous
Peak-to-peak output voltage: Power Supply voltage minus 0.8-1.4 volts (decreasing with load and independent of voltage on the DCC input)
Short Trip Point: 5.6 Amps
Short Trip Off Time: 1 microsecond
Short Trip Recovery Time: 200 microseconds
Board Size: 3″ long x 2.5″ wide x 0.5″ deep (including heatsink) (76mm x 64mm x 12mm). Green blocks extend another 0.3″ (8mm).
The USPS is currently not delivering to Australia or New Zealand. As a result, we are not sending any orders to these two countries temporarily. As soon as the USPS lifts their restriction, we will resume shipping. We do apologize for this inconvenience! Dismiss