Turtle Stall Motor Driver and DCC Decoder – #TVD-TURT01
Turtle Stall Motor DCC and Local Control Driver Board
This item includes board and mounting kit. For local control you will also need a Fascia Controller. For connecting to a motor the options are to use the jumper wires below, your own wires soldered to the output pins, or a servo extension cable. The MP1 motor requires a 3-wire connection so the servo cable is a good option. The jumper wires connect directly to the the M1 and M2 output pins on the board. The wires can be plugged in to each other to extend the distance beyond 12″. The Turtle w/ Fascia Controller and a Tortoise draws about 10 mA (0.01 A) of power.
Includes mounting screws and spacers.
- Size – 1.15″ x 1.25″ (29mm x 32mm)
- Max Power Supply Voltage – 20V
- Max Motor Drive Current – 1A
- Max LED Drive Current – 20mA
- Max Load Controller Port 5V pin – 100 mA