Furniture listing

A 6 foot four wire coiled cable for cabs. Has RJ12 connectors on both ends. SKU:  05240209

CableRjCoilDIN is a data wired cord for your Lenz or NCE system. It has an RJ11 (telephone style) connector on one end and a DIN (keyboard style) connector on the other end. The 4-wire cables extend to 12 feet.

Connect your computer to your NCE (or other) USB adapter.

USB to RS-232 Cable • USB to RS-232 Serial interface (DB-9 & DB-25) • USB specification rev. 2.0 • Support over 1Mbps data transfer rate • Support remote wake-up and power management • Suitable for PDA and modem • DB-9 to DB-25 adapter included UN8BE USB to Serial DB9 w/DB-25 adapter - Blue Can be connected to your NCE: CSO2 PH-Box PH-Pro PH-ProR PH-10 PH10-R To the USB port on your computer.

A replacement sensor cable for use with the Trainspeed 1 and Trainspeed 4. Perfect if you need to move your Trainspeed to a new layout, or one of your cable gets damaged during layout work. Model: 1558

6 wire, 26 gauge UTP/DIN Panel Wiring

6 wire, 26 gauge UTP/DIN Panel Wiring

6 wire, 26 gauge UTP/DIN Panel Wiring The 7FT can be used with the PowerCab.

Mr. DCC recommends the inexpensive pre-fabricated cables we stock at Litchfield Station. They fill the bill for most modelers. If you are building a lot of cables or need custom lengths, or need 4p4c cables for NCE ControlBus, we have the parts and tools to make your own. For most DCC uses, RJ12 data connected fills the bill. Buy RJ12 ends and wire and the crimping tool and make your own for:

• Digitrax LocoNet
• Lenz based XpressNet, including Atlas and Roco
• NCE CabBus Throttle Network

For NCE CommandBus (the 4 wire connection between command station and booster), buy RJ22 ends and wire and crimping tool.