Furniture listing

The PSXX is designed to specifically handle low power starter systems:

 

• • NCE Power Cab

 

• • Digitrax Zephyr

 

The PSXX has a default trip rate of 2.0 amps

 

• • The PSXX series has the most reliable operating features that protect model railroad equipment and wiring from damage during a short circuit, including fast-acting, solid-state electronics.

 

• • The Power Shields are available in 1, 2, and 3 circuit-breaker models, allowing you to divide the output of a single booster into independent power districts.

 

• • The PSXX circuit board is wired between the DCC system’s booster and the track bus.

 

• The PSXX includes screw terminals for easy connections from the booster and to the track. There is also an extra pair of terminals for linking the booster power input wires to additional PSXX breakers should you need to add extra PSX protected power districts.

 

DCC Specialties and Integrated Signal Systems (ISS) collaborated to develop and design the Block Watcher. The need was due to the fact that at the higher amperages required by high density users, most existing products either create a substantial voltage drop or can become unstable.

A cost effective way to get the Hare's unique features!  

• One Wabbit will operated two Circuitron Tortoise or other stall-type turnout motors
  • simplifies wiring
  • reduces failures
• Auto-Throw feature automatically throws points when a train is approaching against them
• Smart-Route feature sets up to 13 routes by simple address programming in addition to the primary decoder address
• Smart Default Operations: allows all Hare controlled turnouts to move to a predetermined position when layout is powered up or remain as last thrown
• Smart Switch Point Power: Hare has circuitry that not only provides polarized power for power routing, but also has an integrated circuit breaker that turns off power to the switch rails in the event of a track short
• Operates LED Turnout Signals or remote Panel LED Indicators
• Manual Push Button control, as well as DCC control
• System Reset to factory defaults by CV programming
• Combination savings with Tortoise motors

A cost effective way to get the Hare's unique features!  

• One Wabbit will operated two Circuitron Tortoise or other stall-type turnout motors
  • simplifies wiring
  • reduces failures
• Auto-Throw feature automatically throws points when a train is approaching against them
• Smart-Route feature sets up to 13 routes by simple address programming in addition to the primary decoder address
• Smart Default Operations: allows all Hare controlled turnouts to move to a predetermined position when layout is powered up or remain as last thrown
• Smart Switch Point Power: Hare has circuitry that not only provides polarized power for power routing, but also has an integrated circuit breaker that turns off power to the switch rails in the event of a track short
• Operates LED Turnout Signals or remote Panel LED Indicators
• Manual Push Button control, as well as DCC control
• System Reset to factory defaults by CV programming
• Combination savings with Tortoise motors

The Tsunami from SoundTraxx and the QSI decoders, as used in BLI, Atlas, Life-Like, etc. locos, are tamed with a programming track booster. Safe for all decoders, so may be left connected all the time for simple, flawless programming. Includes a "wall-wart" type power supply for 115 VAC mains.